Konica Minolta bizhub C3350 User Manual page 83

2.1 Configuring the Scan to E-mail operating environment
2
In the administrator mode, select [Network] - [E-mail Settings] - [E-mail RX (POP)], then configure the
following settings.
Settings
[E-mail RX (POP)]
[POP Server Address]
[Port Number]
[Login Name]
[Password]
[Connection Timeout]
3
Set the POP over SSL and APOP settings according to your environment. In the administrator mode,
select [Network] - [E-mail Settings] - [E-mail RX (POP)], then configure the following settings.
Settings
[SSL/TLS]
[Port Number (SSL)]
[APOP Authentication]
[Applied Functions]
Description
Select [Enable] to use POP Before SMTP.
[Enable] is specified by default.
Enter the address of your E-mail server (POP).
Use one of the following formats.
• Example of host name entry: "host.example.com"
• Example of IP address (IPv4) entry: "192.168.1.1"
• Example of IP address (IPv6) entry: "fe80::220:6bff:fe10:2f16"
If necessary, change the port number of the E-mail server (POP).
Normally, you can use the original port number.
[110] is specified by default.
Enter the login name when E-mails are received using the E-mail server (POP)
(using ASCII characters of up to 63 bytes).
Enter the password (using ASCII characters of up to 15 bytes).
To enter (change) the password, select the [Change Password] check box,
then enter a new password.
Change the time-out time to communicate with the E-mail server (POP), if nec-
essary.
[60 sec.] is specified by default.
Description
When using SSL to encrypt a communication with the E-mail server (POP), se-
lect [Enable].
[Disable] is specified by default.
If necessary, change the SSL communication port number.
Normally, you can use the original port number.
[995] is specified by default.
If you use APOP in your E-mail server (POP), select [Enable].
[Disable] is specified by default.
2
2-5