When reassembling
Adjust the following SP modes after you replace the lens block assembly:
SP4–008 (Sub Scan Mag): (
SP4–010 (Sub Mag Reg.): (
SP4–011 (Main Scan Reg): (
SP4–688 (DF: Density Adjustment): Use this to adjust the density level if the ID of outputs
made in the DF and Platen mode is different.
4.4.4 ORIGINAL SIZE SENSOR
1.
Exposure glass with left scale (
2.
Scanner right cover (
3.
SBU cover (
p.4-14 "Lens Block Assembly")
4.
Remove the screw [A] on the sensor board bracket.
5.
Circuit chip [A] (
x 1,
SM
"Scanning" in "Copy Adjustments: Printing/Scanning")
"Scanning" in "Copy Adjustments: Printing/Scanning")
"Scanning" in "Copy Adjustments: Printing/Scanning")
p.4-10 "Exposure Glass")
p.4-11 "Scanner Exterior Panels and Operation Panel")
x 1)
4-15
Scanner
D129/D130