Table of Contents
Advertisement
Eliminating Copy Marks Along Borders (Frame/Fold Erasure) (continued)
Use the touch screen keypad or up/down arrow key to enter the desired
erasure amount, from 1 to 300 mm in 1 mm increments.
To specify Fold Erasure amount:
• Touch to highlight FOLD, if not highlighted, then use the touch screen
keypad or up/down arrow key to enter the desired erasure amount, from
1 to 99 mm in 1 mm increments.
5.
Touch OK.
The Application Selection Screen will be restored.
6.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
7.
Enter the desired print quantity from the control panel keypad.
See p. 3-10 for details on setting print quantity.
8.
Position original(s) FACE UP in the document feeder or FACE
DOWN on the platen glass.
For details on positioning originals, see p. 3-4 to p. 3-9.
When lowering the document feeder onto thick original (e.g. open book), do
not press it down too hard. Keep the document feeder open, if required.
9.
Press [START].
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied sets
as they exit; otherwise, mishandled paper will occur.
10-42
Advertisement
Table of Contents
Troubleshooting
