Table of Contents
Advertisement
In Reserve mode, pressing [INTERRUPT] before the copier finishes scanning
the reserve job originals clears the settings selected for the reserve job.
For details of Reserve mode, see p. 3-35 to p. 3-37.
2.
Set copy conditions, as desired.
The initial settings in Interrupt mode are as follows.
Colour Mode
Copy Mode
RADF
AE
Lens Mode
APS
Print Quantity
Finisher
Remove any document from the platen glass or from the document feeder, if
present.
3.
Position original(s).
See p. 3-4 to p. 3-9 for details on positioning originals.
4.
Press [START] to start the interrupt copying.
When [CHECK] is pressed during Interrupt copying, the information displayed
reflects the initial copy job settings. Check mode will not display Interrupt copy
job information.
5.
When Interrupt copying is completed, press [INTERRUPT] again.
The [INTERRUPT] LED turns out and the INTERRUPT indicator on the
Basic Screen returns to the JOB indicators.
The settings of the initial job will be restored on the Basic Screen.
6.
Press [START] to resume copying.
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied sets
as they exit; otherwise, mishandled paper will occur.
: Full Colour
: 1a1
: ON
: ON
: 1.000 (100%)
: ON
: 1
: Sub Tray
Interrupt Copying (continued)
4-9
Advertisement
Table of Contents
Troubleshooting
