Table of Contents
Advertisement
Programming Different Settings for an Output Job (Program Job) (continued)
8.
Repeat steps 4 to 7 until all JOB originals are scanned.
PLACE AND SCAN EACH ORIGINAL SET IN THE CORRECT ORDER OF
PAGINATION.
• Memory overflow may occur during scanning. See p. 5-9 to p. 5-10.
• Should memory overflow occur frequently, it is recommended that you
contact your service representative to expand the memory capacity in your
machine.
9.
Select the desired output mode and enter the print quantity from
the control panel keypad.
See p. 3-10 for details on setting print quantity.
10.
Touch STORE to exit the Store mode.
11.
Press [START].
When the finisher / paper exit tray capacity is exceeded due to the
print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
10-26
Advertisement
Table of Contents
Troubleshooting
