Nortel m3900 series User Manual page 87

Procedure 16
Install a Single KBA Footstand
Step
1
2
3
Procedure 17
Install an Expansion KBA Footstand Assembly
Step
1
2
3
4
5
Copyright © 2008 Nortel Networks
.
Action
Insert the clips on both the telephone and the Key-based
Expansion Module into the hinges on the footstand assembly
and press on the front of the footstand until they snap into place.
While squeezing the telephone and KBA tilt handles, swing the
footstand into the desired position.
Turn the new assembly upright.
Action
Place the Single KBA Footstand Assembly and the Expansion
KBA Footstand Assembly face down on a flat surface.
Align the Expansion KBA Footstand Assembly with the Single
KBA Footstand Assembly and slide them together.
Insert two screws through the Expansion KBA Plate into the
Single KBA Footstand Assembly (see
Footstand" (page
Figure 18
Expansion KBA Footstand
Tighten all four screws, ensuring that the two footstand
assemblies are properly aligned.
Insert the clips on the telephone and the Key-based Expansion
Modules into the hinges on the combined Single/Expansion
KBA Footstand Assembly, and while squeezing the Module Tilt
Handles, swing the footstand into the desired position.
Nortel Communication Server 2100
M3900 Series Meridian Digital Telephones User Guide
NN42200-110 09.01 Standard
20 August 2008
Key-based Expansion Module Accessory (KBA) 87
--End--
87)).
Figure 18 "Expansion KBA