Meridian External Alerter And Recording Interface (Meari) - Nortel m3900 series User Manual

80 Installation
•
•
•
Flexible voice and data capabilities allow you to have continuous use of
both the Meridian Digital Telephone and the attached analog device. Your
system administrator configures the flexible voice and data capabilities
for your telephone on the system equipment. Contact your system
administrator for more information about flexible voice and data capability.
When there is a power failure to the ATA, the Analog Device does not
store or keep information (for example, outgoing FAX from your FAX
machine). You must send the information again when power returns.
Table 18 "ATA configuration" (page 80)
when configuring the ATA.
Table 18
ATA configuration
Prompt
SO
LCC
Ringtype, group, subgroup,
NCOS, SNPA, key, ringing
LEN_OR_LTID
OPTKEY

Meridian External Alerter and Recording Interface (MEARI)

Install the MEARI in the small dock of a M3902, M3903, M3904, or
M3905 set. There are three output connectors on the back of the MEARI
cartridge. There is no need to disconnect the power supply from the
telephone prior to insertion or extraction of the MEARI cartridge.
Copyright © 2008 Nortel Networks
.
Flashing red - indicates that the ATA is operating normally. For more
troubleshooting guidelines, refer to the user documentation that came
with your analog device.
Solid red - indicates that the ATA is not operating normally.
Red light off - indicates that there is no power going to the ATA or the
unit is not operating correctly. Check the power connections to the
ATA.
Response
NEW
ATA
Follow normal administration
procedures for an M3901 telephone
for these prompts.
A B C D
$
Nortel Communication Server 2100
M3900 Series Meridian Digital Telephones User Guide
NN42200-110 09.01 Standard
20 August 2008
shows prompts and responses
Description
Establish service for
unassigned telephone
lines.
Analog terminal adapter line
class code.
The prompts require datafill
specified by the customer
site.
A = IPE column.
B = IPE shelf.
C = IPE card slot.
D = IPE odd port.
There are no options
available for the ATA.