Important Safety Instructions; Important Notices - Bosch MIC-7130-PB4 Operation Manual

MIC IP starlight 7000 HD
1.4

Important Safety Instructions

Read, follow, and retain all of the following safety instructions. Heed all warnings on the unit
and in the operating instructions before operation.
Caution!
TO REDUCE THE RISK OF ELECTRIC SHOCK, DISCONNECT THE POWER SOURCE WHILE
!
INSTALLING THE DEVICE.
Caution!
Installation must be made by qualified personnel and conform to ANSI/NFPA 70 (the National
!
Electrical Code
and all applicable local codes. Bosch Security Systems, Inc. accepts no liability for any
damages or losses caused by incorrect or improper installation.
Warning!
ROUTING OF EXTERNAL WIRING MUST BE DONE THROUGH A PERMANENTLY EARTHED
!
METAL CONDUIT.
Warning!
THE CAMERA MUST BE MOUNTED DIRECTLY AND PERMANENTLY TO A NON-COMBUSTIBLE
!
SURFACE.
–
–
Use common-sense safety precautions, especially in situations where there could be risk of
injury if any part of the assembly becomes detached and falls. Bosch recommends using the
hinged DCA, which allows installers to "hang" the MIC camera temporarily on the DCA to
make electrical connections, before bolting the camera to the DCA.
–
–
–
Warning!
Moving parts!
!
Moving parts may result in risk of injury, therefore, the device should be mounted so that it is
accessible only to the technician/installer.
1.5

Important Notices

Notice!
This device is intended for use in public areas only.
U.S. federal law strictly prohibits surreptitious recording of oral communications.
Bosch Security Systems
®
(NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1),
Do not place a canted (45°) camera upright; it can fall over easily. Place the canted
camera on its side.
Do not open the camera unit. Doing so will invalidate the warranty.
Ensure that the unit case is properly earthed. If the product is likely to be struck by
lightning, ensure that earth bonding connections are made correctly to the mounting of
the base of the unit.
Do not point the camera at the sun. Bosch Security Systems will not be liable for any
damage to cameras that have been pointed directly at the sun.
Before transporting, supply power to the camera and rotate the ball so that the window
points toward the base. This will help to protect the wiper and the window during transit.
Operation Manual
Safety | en 7
2016.07 | 5.0 | F.01U.291.520