34
en | Cant the Camera
6. Reinsert the screws into both yoke arms. Note the letter assigned to each screw in the
figure below. You will tighten the screws in a specific sequence that references each letter.
Figure 11.15: Reinsert yoke arm screws (ABCD)
7. Using a torque wrench (user-supplied), tighten the screws to the proper torque using the
sequence described in the table below.
8. Recheck all four screws to ensure the proper torque value.
Torque requirements for yoke arm screws
A
B
A
A
C
A
B
2016.07 | 5.0 | F.01U.291.520
B
A
C
D
B
B
D
C
D
C
D
C
D
SN ≤ xxxxxxx46028xxxxxx
(≤ Dec. 2014)
T30/T27 Torx
≈ 7.5 N m
(≈ 5.5 ft lb)
≈ 15 N m
(≈ 11 ft lb)
≈ 15 N m
(≈ 11 ft lb)
≈ 15 N m
(≈ 11 ft lb)
Operation Manual
MIC IP starlight 7000 HD
SN ≥ xxxxxxx46029xxxxxx
(> Dec. 2014)
5 mm Hex
(T30 Torx)
≈ 7.5 N m
(≈ 5.5 ft lb)
≈ 17 N m
(≈ 12.5 ft lb)
≈ 17 N m
(≈ 12.5 ft lb)
≈ 17 N m
(≈ 12.5 ft lb)
Bosch Security Systems