Bosch MIC-7130-PB4 Operation Manual page 45

MIC IP starlight 7000 HD
2.
3.
Display milliseconds
If necessary, you can also display milliseconds. This information can be useful for recorded
video images; however, it does increase the processor's computing time. Select Off if you do
not need to display milliseconds.
Alarm mode stamping
Select On to display a text message overlay in the image in the event of an alarm. It can be
displayed at a position of your choice that you can then specify using the Custom option. Or it
can be set to Off for no overlay information.
1.
2.
3.
Alarm message
Enter the message to be displayed in the image in the event of an alarm. The maximum text
length is 31 characters.
Title OSD
Select On to continuously display sector or shot title overlays in the image. Select Momentary
to display sector or shot title overlays for a few seconds. OSD titles can be displayed at a
position of your choice, or it can be set to Off for no overlay information.
1.
2.
3.
Camera OSD
Select On to momentarily display camera response information, such as Digital Zoom, Iris
open/close, and Focus near/far overlays in the image. Select Off to display no information.
1.
2.
3.
Transparent background
Check this box to make the stamp on the image transparent.
Video authentication
Select a method for verifying the integrity of the video in the Video authentication drop-down
box.
If you select Watermarking all images are marked with an icon. The icon indicates if the
sequence (live or saved) has been manipulated.
If you want to add a digital signature to the transmitted video images to ensure their integrity,
select one of the cryptographic algorithms for this signature.
Enter the interval (in seconds) between insertions of the digital signature.
Signature intervals
Select the interval (in seconds) for the signature.
Bosch Security Systems
If you select the Custom option, additional fields are displayed where you can specify the
exact position (Position (XY)).
In the Position (XY) fields, enter the values for the desired position.
Select the desired option from the list.
If you select the Custom option, additional fields are displayed where you can specify the
exact position (Position (XY)).
In the Position (XY) fields, enter the values for the desired position.
Select the desired option from the list.
Specify the exact position (Position (XY)).
In the Position (XY) fields, enter the values for the desired position.
Select the desired option from the list.
Specify the exact position (Position (XY)).
In the Position (XY) fields, enter the values for the desired position.
Operation Manual
General | en 45
2016.07 | 5.0 | F.01U.291.520