Bosch MIC-7130-PB4 Operation Manual page 118

118 en | Keyboard Commands
Function Command
Key No.
On/Off 95
On/Off 96
On 99
On/Off 100
On/Off 101
On/Off 102
On/Off 103
On/Off 104
On/Off 105
On/-- 149
On 606
On/Off 700
On/Off 804
On/Off 908
On 911
Set 62
Set "1-99"
Shot "1-99"
2016.07 | 5.0 | F.01U.291.520
Command
Display Azimuth/Elevation
Readings
Display Compass (Point)
Readings
Factory P/T Home Position
Record Tour A
Record Tour B
Wiper On/Off
Wiper On/Off
Wiper On/Off
Wash/Wipe On/Off
Reset Position Correction
Counters
Power Mode
Proportional Speed Control
adjustment
Mask Calibration Procedure
Privacy Mask Enlargement
Camera Reboot
Washer
Pre-position Programming
Pre-position Recall
Description
On–Displays azimuth/elevation readings.
Off–Hides azimuth/elevation readings.
Refer to Azimuth, Elevation, and Compass
Directions.
On–Displays compass heading.
Off–Hides compass heading.
Refer to Azimuth, Elevation, and Compass
Directions.
Recalibrates home position; can be used as an
Alarm Output.
Starts/stops recording Tour A.
Starts/stops recording Tour B.
On: Continuous wiper mode, stops
automatically after five minutes.
On: Intermittent; wipes twice, then turns off
after 15 seconds. This cycle repeats until turned
OFF.
On: One-shot; wipes five times, then turns off.
On: Camera moves to designated washer preset
62, wiper & washer automatically start.
On: Reset position correction counters.
Temporarily displays current power mode "24
VAC:", "POE+", "POE++", or "Unknown").
On – Increase Proportional Speed
Off – Decrease Proportional Speed
Overlay feedback provided. Speeds cycle
through Super Slow, Slow, Medium, and Fast.
Manual procedure to calibrate masks (privacy
and virtual).
Turns privacy mask enlargement on/off during
PTZ movement.
Forces the camera to complete the power on
boot sequence. AUTODOME cameras will
complete "Finding Home".
Activate washer.
Set ##–Programs a preset view.
Shot ##–Recall programmed preset.
Operation Manual
MIC IP starlight 7000 HD
Bosch Security Systems