Using The Configuration Manager; Using The Web Server Of The Camera - Bosch MIC-7130-PB4 Operation Manual

40 en | Configuration
–
–
–
–
Notice!
Ensure that the network parameters of your camera are available before you begin
configuration. Contact your local network administrator for a valid IP address, Subnet mask,
and Gateway IP address.
The following sections provide instructions about installing the software necessary to view
images over an IP connection, configuring the IP network settings, and accessing the camera
images from a Web browser.
To change the IP address or any network settings, you can use:
–
–
13.2.1

Using the Configuration Manager

Configuration Manager is an optional network utility provided on the Bosch Security Systems
Web site. Use the Configuration Manager Manual to make any configuration changes.
Note: Depending on the PC network security settings, the user may need to add the new IP
address to the browser's trusted sites list for the controls to operate.
13.2.2

Using the Web Server of the Camera

1.
2.
3.
4.
5.
6.
7.
Note: The Set button changes to Set and Reboot.
4
2016.07 | 5.0 | F.01U.291.520
Unit IP address: An identifier for the camera on a TCP/IP network.
Default: 192.168.0.1 (if your network does not have a DHCP server)
or
the first available IP address (if your network has a DHCP server)
Note: You will likely need to change the IP address of your camera so that it does not
conflict with another device on your network. Refer to the section Network > Network
Access for more information.
Subnet mask: A mask used to determine what subnet an IP address belongs to.
Default: 255.255.255.0
Gateway IP address: A node on a network that serves as an entrance to another network.
Default: 0.0.0.0
Port: An endpoint to a logical connection in TCP/IP and UDP networks. The port number
identifies the use of the port for use through a firewall connection.
the Configuration Manager software or
the MIC7000 Series server.
Set the IP address on the network device to 192.168.0.10 to ensure that the network
device and the camera are on the same Subnet.
Launch your web browser (such as Microsoft Internet Explorer) and navigate to the
following URL: http://192.168.0.1. The web browser opens the Live page for the camera;
a security warning message appears.
Select the box Always Trust, and then click YES.
Click Configuration at the top right of the page.
Select Network. The menu expands.
Select Network Access. The page Network Access opens.
Configure the settings on this page based on the addresses provided by your local
network administrator.
Click Set and Reboot. The camera will reset (go through the homing sequence, which
usually takes 30 seconds to complete), and then the Live page appears, with updated
video and the new IP address.
Operation Manual
MIC IP starlight 7000 HD
Bosch Security Systems