Saving And Using The New Configuration; Setting The System Date And Time - HP ProCurve 8100fl Series Installation And Getting Started Manual

Getting Started With Switch Configuration
Setting Basic System Information

Saving and Using the New Configuration

To apply the system commands entered in the previous steps to the startup
configuration, follow the steps below:
1. To display the running configuration, enter the following command:
2. To save the configuration changes from the running configuration to the

Setting the System Date and Time

To set the system date and time:
1. From the Privileged Exec mode (#) prompt, enter the clock set command:
2. To verify your settings, enter the show clock command:
3-4
Switch 8100fl(config)#show running
For example:
Switch 8100fl(config)#show running
!
interface Management0
no shutdown
ip address 10.10.1.45/21
!
ip telnet
no shutdown
!
line vty 0
!
line vty 1
!
line vty 2
!
end
startup configuration file, enter the write memory command:
Switch 8100fl(config)#write memory
The switch reinstates all configuration changes for the next reboot.
Switch 8100fl#clock set <HH:MM:SS> <1...31> <month> <year>
Switch 8100fl#show clock