Draytek VIGOR2925 SERIES User Manual page 727

ipwd
ivj
ikey
imeth
For TCP/IP Settings
mywip
rgip
rnip
rnmask
rip
mode
droute
E x a m p l e
E x a m p l e
> vpn option 1 idle=250
% Change Log..
% Idle Timeout = 250
It means Dial-in Password.
"ipwd=1234" means to set password as "1234".
It means VJ Compression.
"ivj=on/off" means to enable /disable VJ Compression.
It means IKE Pre-Shared Key.
"ikey=abcd" means to set IKE Pre-Shared Key = abcd.
It means IPSec Security Method
"imeth=h" means "Allow AH".
"imeth=d" means "Allow DES".
"imeth=3" means "Allow 3DES".
"imeth=a" means "Allow AES.
It means My WAN IP.
"mywip=1.2.3.4" means to set My WAN IP as "1.2.3.4".
It means Remote Gateway IP.
"rgip=1.2.3.4" means to set Remote Gateway IP as "1.2.3.4".
It means Remote Network IP.
"rnip=1.2.3.0" means to set Remote Network IP as "1.2.3.0".
It means Remote Network Mask.
"rnmask=255.255.255.0" means to set Remote Network
Mask as "255.255.255.0".
It means RIP Direction.
"rip=d" means to set RIP Direction as "Disable".
"rip=t" means to set RIP Direction as "TX".
"rip=r" means to set RIP Direction as "RX".
"rip=b" means to set RIP Direction as "Both".
It means the option of "From first subnet to remote network,
you have to do".
"mode=r" means to set Route mode.
"mode=n" means to set NAT mode.
It means to Change default route to this VPN tunnel ( Only
single WAN supports this).
droute=on/off means to enable/disable the function.
711
Vigor2925 Series User's Guide