Telnet Command: Srv Dhcp Public - Draytek VIGOR2925 SERIES User Manual

S y n t a x D e
S y n t a x D e
Parameter
[<command>
<parameter>|...]
-l<enable>
-m<enable>
-e<id>
-d<id>
-v
E x a m p l e
E x a m p l e
> srv dhcp dhcp2 -l 1 -e 1
> srv dhcp dhcp2 -v
2nd DHCP server flag status --
Server works on specified MAC address: ON
Server works on specified LAN port: ON
Port 1 flag: ON
Port 2 flag: ON
Port 3 flag: OFF
Port 4 flag: OFF
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command allows users to configure DHCP server for second subnet.
srv dhcp public start [IP address]
srv dhcp public cnt [IP counts]
srv dhcp public status
srv dhcp public add [MAC Addr XX-XX-XX-XX-XX-XX]
srv dhcp public del [MAC Addr XX-XX-XX-XX-XX-XX/all/ALL]
S y n t a x D e
S y n t a x D e
Parameter
start
IP address
cnt
IP counts
s c r i p t i o n
s c r i p t i o n
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one
line.
It menas to enable the LAN port to public DHCP.
0: Disenable
1: Enable
It menas to enable MAC address to public DHCP.
0: Disenable
1: Enable
It menas to turn on the flag of LAN port 1/2/3/4.
It menas to turn off the flag of LAN port 1/2/3/4.
It menas to view current status.
: s r v d h c p p u b l i
: s r v d h c p p u b l i
s c r i p t i o n
s c r i p t i o n
Description
It means the starting point of the IP address pool for the
DHCP server.
It means to specify an IP address as the starting point in the
IP address pool.
It means the IP count number.
It means to specify the number of IP addresses in the pool.
c
c
667
Vigor2925 Series User's Guide