Telnet Command: Ip6 Internet - Draytek VIGOR2925 SERIES User Manual

T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure settings for accessing Internet.
ip6 internet -W n -M n [-<command> <parameter> | ... ]
S y n t a x
S y n t a x
Parameter
-W n
-M n
[<command>
<parameter>|...]
-m n
-u <username>
-p <password>
-l n
-s <server>
-d <server>
-D <server>
-t <dhcp/ra/none>
Vigor2925 Series User's Guide
a n d : i p 6 i n t e r n e t
a n d : i p 6 i n t e r n e t
D e s c r i p t i o n
D e s c r i p t i o n
Description
W means to set WAN interface and n means different
selections. Default is WAN1.
n=1: WAN1
n=2: WAN2
n=3: WAN3
.
.
n=X: WANx
M means to set Internet Access Mode (Mandatory) and n
means different modes (represented by 0 – 5)
n= 0: Offline,
n=1: PPP,
n=2: TSPC,
n=3: AICCU,
n=4: DHCPv6,
n=5: Static
n=6:6in4-Static
n=7:6rd
The available commands with parameters are listed below.
[...] means that you can type in several commands in one
line.
It means to set IPv6 MTU.
N = any value (0 means "unspecified").
It means to set Username.
<username>= type a name as the username (maximum 63
characters).
It means to set Password.
<password> = type a password (maximum 63 characters).
It means to set IPv6 prefix length for protocol of 6rd.
n: IPv6 prefix length.
It means to set Tunnel Server IP.
<server>= IPv4 address or URL (maximum 63 characters).
It means to set the primary DNS Server IP.
<server>= type an IPv6 address for first DNS server.
It means to set the secondary DNS Server IP.
<server>= type an IPv6 address for second DNS server.
It means to set IPv6 PPP WAN test mode for DHCP or
618