Front Bumper Components Replacement - Lifan 620 Maintenance Manual

www.CarGeek.ir
1. Removal
1) Remove trim strip of instrument panel and A/C control panel.
2) Remove the two screws fastening instrument panel and auxiliary fascia console under the A/C
control panel.
3) Remove and replace screw 3 (2 screws in left and right)
4) Remove floor type handbrake cover board.
5) Open sundries case cover of auxiliary fascia console and remove the two bolts in the bottom.
6) Remove auxiliary fascia console assembly.
XII. Front bumper components replacement (Fig. 7-43)
Fig. 7-43
1. Cross slot recessed hexangular head self-tapping screw 2. Rubber head bolt 3. Plastic buckle
4. Cross slot cup head self-tapping screw 5. Front grille 6. Mark 7. Front bumper
8. Cross slot hexangular head self-tapping screw
1. Remove front grille
Remove the mounting buckle of front grille and two rubber head bolts.
2. Disconnect the 3 jack catches and remove grille with a screwdriver.
Note: Wrap the screwdriver tip with adhesive tape before use.
354
www.cargeek.ir