Check The Operation Status Of Inner Light Delay System - Lifan 620 Maintenance Manual

voltage as well as conductivity between terminals of flash wire connector. If the check results can
not meet the requirements in the table, check corresponding circuit. To find more, refer to Fig. 4-89
and Table 4-14.
Testing terminal
(2-7)―body
(2-8)―body
(2-9)―body
(3-17)―body
(3-18)―body
(3-35)―body

8. Check the operation status of inner light delay system

(1) Main components: Ignition key ring indicator, rear roof light.
(2) The ignition key is pulled out.
(3) When the roof light switch is at "DOOR", upon unlocking by remote control or opening of any
door, the roof light is lightened. If no door is opened within 30 seconds after unlocking by remote
control, the light goes out; (open the door) 8 seconds after close the door, linear weakening occurs
to the brightness, the light gradually goes out within another 5 seconds; press the locking key on
remote controller after the door is closed, the roof light goes out immediately.
(4) Open the left front door when the ignition key is pulled out, the key ring indicator will lighten for
30 seconds, if the left front door is closed within the 30 seconds, the key ring indicator will go out
15 seconds after the closing; when the key is inserted into the ignition lock, the indicator goes out
immediately; when the key is pulled out, the indicator lightens and goes out after 15 seconds.
www.CarGeek.ir
Fig. 4-89
Table 4-14
Wire color
B/R Press the emergency light switch, always
N/R Left combination switch at turn left, always
N/B Left combination switch at turn right, always
R/Y Left combination switch at turn left, always
N/Y Left combination switch at turn right, always
R/G Steering light constant power input
245
www.cargeek.ir
Test condition
Standard
value
Less than 1Ω
Less than 1Ω
Less than 1Ω
10～14V
10～14V
10～14V