Lifan 620 Maintenance Manual page 341

①
Remove the bolts .
② Hold the side back assembly upwardly along the direction of the arrowhead so as to separate
the armrest pothook with the body, as shown in Fig. 7-18.
Note: If the pothook is damaged during the removal, renew the side back assembly.
(3) Remove the right side back assembly in accordance with the process of the left side back,
mentioned above.
(4) Remove the rear seat cushion assembly, referring to the Fig. 7-10.
Pull upwardly the two bulging parts in the front of the seat cushion and remove them.
Note: The pad bracket is easy to be deformed. In order to avoid the deforming, make sure the
hands beside the two pothooks as shown in the figure.
3. Installation process:
(1) Install the rear seat cushion, referring to Fig. 7-15.
①
Push the cushion backwardly to make the back pad pin the cushion.
② Put the frame pothook of the seat on the two buckle seat assemblies (front side).
Note: Confirm the fastness of the seat cushion.
(2) Install the left armrest assembly.
①
Reverse to the removal steps, press the armrest along the direction
fix the pothook on the body.
②
Install the hinge with bolts at the torque of 9.8N·m.
(3) Installing the right rear seat side back assembly shall conform to the steps of left armrest
www.CarGeek.ir
Fig. 7-18
Fig. 7-19
340
www.cargeek.ir
shown in Fig. 7-19 so as to