Lifan 620 Maintenance Manual page 348

(2) Fix the buckle on the buckle installing bracket (Total: 2) of the A pillar upper guard panel. First
put the front small buckle foot into the corresponding installing holes on the dash board, the two
buckles into the buckle holes of the A pillar metal sheet so that the A pillar upper guard panel can
be fixed.
(3) Firm the inner felt pad of the C pillar upper guard panel and five fixing buckles on the C pillar
upper guard panel. First put the rear side small buckle foot into the metal sheet hole of the C pillar
and five buckles into the buckle hole of the C pillar metal sheet so that the C pillar upper guard
panel can be firmed.
(4) Make the small buckle foot on the lower part of the B pillar upper guard panel into the metal
sheet hole of the B pillar and press the buckle on the upper side into the corresponding round
holes of the B pillar so that the B pillar can be fixed, as shown in Fig. 7-28.
(5) Install the two fixing buckles into the buckle bracket of the B pillar lower guard panel and the
column at the upper side of the B pillar lower guard panel into the B pillar upper guard panel holes,
and put the buckle foot in the appropriate position (as shown in the following figure). Two fixing
buckles shall be installed in the buckle holes.
(6) Make the snap spring fixed on the A pillar lower guard panel clip the brim of the metal sheet
and press ahead. Install the buckles on the bolt from the inner side and press the A pillar lower
guard panel inward tightly.
(7) Install the front and rear door sill guard panel, press the end of the door sealing strip under the
door sill guard panel and put the small column connecting to the B pillar lower guard panel into the
corresponding round hole on the B pillar lower guard panel, and place the buckles (3 buckles see
D; 2 buckles see C.) under it into the corresponding installing holes of the body, and the small
buckle foot connecting to the B pillar lower guard panel, in position. See Fig. 7-29.
Note: The buckles at the lower side of the door sill guard panel shall aim at the metal sheet buckle
www.CarGeek.ir
Fig. 7-28
Fig. 7-29
347
www.cargeek.ir