Lifan 620 Maintenance Manual page 127

19) Remove the ignition switch lock core assembly as shown in Fig. 2-36.
① Turn the ignition switch to position ACC.
Press down the lock by a screwdriver and pull out the lock core.
②
20) Dismantle the unlocked warning switch assembly.
Disconnect the unlocked warning switch from the ignition switch ass
①
Dismantle the unlocked warning switch assembly.
②
21) Remove the ignition switch assembly. Remove the 2 bolts and also the ignition switch
assembly from the steering column bracket.
(2) Installation
1) To install the ignition switch assembly and the unlocked warning switch assembly, reverse the
removal procedure.
2) Install the ignition switch lock core assembly.
Make sure that the ignition switch is at position ACC.
①
② Install the ignition switch lock core assembly.
3) Check the action of steering lock.
Check the steering locking
①
Check the steering locking
②
4) Install the switch support on the steering column.
(1) Adopt two new conical bolts for the temporary installation of the switch support assembly and
the clip on the steering column.
(2) Screw up the two conical bolts till their nut heads disconnect.
5) Install No. 2 steering intermediate shaft assembly.
Align the matching mark on the intermediate s
①
② Install the intermediate shaft with bolt.
6) Install the steering column assembly.
Install the steering column assembly with three bolts.
①
Connect the connector to the harness c
②
7) Connect No. 2 steering intermediate shaft assembly.
① Align the matching mark on the intermediate shaft and slip yoke.
Install the bolt B and screw down bolt A.
②
8) Install the cover board of the steering column hole.
9) Install wiper switch. Install the wiper switch assembly and connector.
10) Install the headlamp dimmer switch assembly. Install the headlamp dimmer switch assembly
and connector.
11) Make the front wheel in the straight ahead position.
12) Install the clock spring when the key is at position ACC.
13) Check the inter-locking of the key.
www.CarGeek.ir
Fig. 2-36
mechanism with the key out.
mechanism for its activeness with the key in position ACC.
haft and main shaft.
Tightening torque: 36N·m.
lip.
Tightening torque: 28N·m.
126
www.cargeek.ir
embly.
Tightening torque: 21N·m.