Rear Side Door Lock; Rear Side Door Assembly - Lifan 620 Maintenance Manual

www.CarGeek.ir
2) Disconnect the motor harness of the electric glass frame riser.
3) Remove the bolt of the glass frame riser, and take out the glass frame riser.
2. Exam:
1) Check whether the components for movement and rotation of the glass frame riser need
lubricating or not.
2) Check whether the trolley is frayed or damaged.
3. Installation: Install the front window glass frame riser as per the reverse order.
Note: During the installation of the glass, check whether the top of the glass and the sliding
channel contact evenly or not, and the up-and-down movement is stable or not.
IV. Rear side door lock:
1. Removal:
(1) Remove the rear side door glass frame riser switch assembly.
(2) Remove the rear side door ornamental guard panel.
(3) Remove the rear side door sealing film.
(4) Remove the movable guide rail of the rear side door and the triangle window glass to avoid
damage.
(5) Remove the front side door inner handle, rear door lock assembly in order after disconnecting
the joints of every controlling rod. (The rear door outside handle is removed at last.)
2. Installation: Installing as per the reverse order, and pay attention to the following points:
①
Install and adjust the locking ring. Move the locking ring up and down so as to make its axis
nearly line with the door lock groove, and screw the bolt tightly.
Note: The locking ring shall be placed in a horizontal position and moved up and down, and don't
adjust the door lock.
②
Make the door keep contact with the body when closed.
Note: Inject the oil or grease lubricant into the joint of the locking ring regularly.
V. Rear side door assembly:
1. Removal:
(1) Disconnect the door harness.
(2) Remove the door limiter.
(3) Use the jack and underlay a piece of wood between the jack and the door plate to support the
door plate.
(4) Unscrew the hinge bolt so as to remove the door assembly. (When removing the rear door top
and bottom hinges, unscrew the bolts.)
2. Installation: install the rear side door as per the reverse order.
(1) Coat the hinge installing surface with the sealant and the rotation components with grease
lubricant.
(2) The induration of the sealing strip will lead to the leakage. In such conditions, renew the strip.
(3) Adjust the position of the door locking ring according to "door lock installation", so as to locate
the door correctly.
(4) Keep the door contact with the boy when closed.
(5) Check the door gap through opening and closing the door after installation. When the gap
exists, adjust the door.
333
www.cargeek.ir