Rear Seat Safety Belt; Notes For Safety Belt Maintenance - Lifan 620 Maintenance Manual

www.CarGeek.ir
acceptable.
(2) Make sure that screw the fixing bolt to the designated torque, refer to the Fig. above.
(3) Tightening torque (a): 45N·m
II. Rear seat safety belt:
1. Removal, as shown in Fig. 7-4.
Fig. 7-4
a. Fastener torque 45N·m
(1) Disconnect the cathode cable from the battery
(2) Deactivate the air bag system.
(3) Remove the rear seat side back.
(4) Remove the rack board guard panel assembly.
(5) Remove the fixing bolt of the rear safety belt retractor.
(6) Remove the rear seat cushion.
(7) Remove the fixing bolt at the lower end of the s
(8) Remove the rear safety belt assembly from the body.
2. Installation: The order of the installation is opposite with that of the removal.
III. Notes for safety belt maintenance:
Read the following notes before repairing and renewing the safety belt:
1. The safety belt shall connect normally to the retractor and buckle lock.
2. Don't let the sharp and destructive stuffs approach to the safety belt.
3. Avoid bending or damaging any parts of the buckle lock or lock plate.
4. Don't blanch or dye the belt (only the cleanout with the mild soap and warm water is
acceptable).
5. Hold the pre-tightening screw to avoid the floss when installing the safety belt.
6. Don't try to repair the retractor or the retractor cap; renew the deficient assembly with the new
one.
7. Keep the belt dry and clean.
8. Renew the deficient components if necessary.
9. Renew the belt cut off or damaged by other ways.
10. Don't fill the hole of the ornamental panel, gone through by the safety belt, with any stuffs.
329
www.cargeek.ir