Check The Oil Level In The Reservoir; Inspection Of Brake Pedal; Adjust The Pedal Height; Check The Free Play Of The Pedal - Lifan 620 Maintenance Manual

www.CarGeek.ir
2) Step down the pedal for times and then keep it stepped down, and then screw off the air
discharging bolt.
3) Screw down the air discharging bolt immediately when the brake fluid flows out, and release the
brake pedal.
4) Repeat step 2) and 3) until all air in brake fluid flow out.
5) Repeat the above steps to exhaust air from each brake slave cylinder. Tightening torque:
8.0N·m.

4. Check the oil level in the reservoir

Check the oil level. Refill brake fluid if necessary. Brake fluid: DOT4
ii. Inspection of brake pedal
1. Check the pedal height as shown in Fig. 2-43. Height above floor: 136mm-146mm.
Fig. 2-43

2. Adjust the pedal height.

1) Remove the central console cover.
2) Dismantle the connector from the brake lamp switch.
3) Release the brake lamp switch locking nut and dismantle the brake lamp switch.
4) Release the locking nut of U connector.
5) Rotate the push rod of pedal, and adjust the pedal height.
6) Screw down the locking nut of the push rod. Tightening torque: 26N·m.
7) Install the brake lamp switch.
8) Insert the connector of brake lamp switch.
9) Push down the brake pedal for 5-15mm, and then turn the brake lamp switch until the lamp
goes out. Then lock the nut.
10) After installation, step down the brake pedal for 5-15 mm, and then check if the lamp is lighted
(it should be lighted).

3. Check the free play of the pedal

134
www.cargeek.ir