Lifan 620 Maintenance Manual page 174

C1 202 C1 205
DTC
C1 208 C1 211
Air gap error: no signal because of
air gap too large or sensor short
Cause
circuit (resistance is 0), or gear ring
is not properly installed.
Elimination
procedure
※
. Air gap adjust
☞ Not to adjust the type of air gap, but to set automatically according to the tolerance of relevant
part. As a result, confirm the part with abnormal air gap and replace or adjust to specified air gap (by
burnishing the mounting surface contact area of sensor); a thin washer should be placed on the
mounting surface of sensor to adjust to specified air gap.
www.CarGeek.ir
Table 3-10
①
Note:
②
If faults corresponding to more than 2
confirmed, delete the DTC (that can be deleted), drive the
vehicle at a speed of over 40 km/h, confirm the fault
corresponding to this DTC again and refer to the recorded
DTC (and confirm the same DTC).
ment method
173
www.cargeek.ir
Air gap is the gap between gear ring and sensor;
DTC can be