Configuring Bridge Sta - Alcatel OmniStack 8008 User Manual

Configuring Bridge STA

The following figure and table describe Bridge STA configuration.
<APPLY>
The state of spanning tree protocol on the system.
Use <TAB> or arrow keys to move, <Space> to scroll options.
Parameter
Spanning Tree Protocol
Priority
Hello Time
Alcatel OmniStack 8008
< Spanning Tree Bridge Configuration >
Spanning Tree Protocol
Bridge Priority
Hello Time (in seconds)
Max Age (in seconds)
Forward Delay (in seconds) : 15
Default
On
32,768
2
<OK>
Description
Enable this parameter to participate in an STA-compliant
network.
Device priority is used in selecting the root device, root
port, and designated port. The device with the highest
priority becomes the STA root device. However, if all
devices have the same priority, the device with the
lowest MAC address will then become the root device.
Enter a value from 0 - 65535.
Remember that the lower the numeric value, the higher
the priority.
Time interval (in seconds) at which the root device
transmits a configuration message.
The minimum value is1.
The maximum value is
the lower of 10 or [(Max. Message Age / 2) -1].
Configuring the Switch
: On
: 32768
: 2
: 20
<CANCEL>
| READ/SELECT
2-25