Ip Configuration - Alcatel OmniStack 8008 User Manual

Console Interface

IP Configuration

Use the IP Configuration screen to set the bootup option, or configure the switch's IP
parameters. The screen shown below is described in the following table.
IP address of this system for ethernet type.
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter Default
Interface Type Ethernet
IP Address 192.168.10.1
Subnet Mask 255.255.255.0
Default 0.0.0.0
Gateway
IP State USER-CONFIG
2-10
Alcatel OmniStack 8008
< IP Configuration >
Interface Type : Ethernet
IP Address
Netmask
Default Gateway : 10.1.0.254
IP State
<APPLY>
Description
Indicates IP over Ethernet.
IP address of the switch you are managing when accessing it over
the network. The switch supports SNMP over UDP/IP transport
protocol. In this environment, all systems on the Internet, such as
network interconnection devices and any PC accessing the switch
must have an IP address.
Valid IP addresses consist of four decimal numbers, of 0 to 255,
separated by periods. Anything outside of this format will not be
accepted by the configuration program.
Subnet mask of the switch. This mask identifies the host address
bits used for routing to specific subnets.
The gateway that the switch's agent uses to pass data to the
management station. Note that the gateway must be defined if the
management station is located in a different IP segment.
Specifies whether IP functionality is enabled via manual
configuration, or set by Boot Protocol (BootP). Options include:
USER-CONFIG -IP functionality is enabled based on the default or
user specified IP configuration.
: 192.168.10.1
: 255.255.255.0
: USER-CONFIG
<OK> <CANCEL>
| READ/WRITE