Checking The Engine-Oil Level - Toro 07385H Operator's Manual

1. Latch handle
2. Latch gate

Checking the Engine-oil Level

Service Interval: Before each use or daily
Engine oil type: Detergent diesel engine oil API CH-4 or
higher
Engine-oil viscosity: Choose an engine-oil viscosity
according to the ambient-air temperature to the table in
Figure 14.
Note: The best time to check the engine oil is when the
engine is cool before it has been started for the day. If the
Figure 13
3. Latch pin
Figure 14
engine has already ran, allow the oil to drain back down to the
sump for at least 10 minutes before checking. If the oil level
is at or below the Add mark on the dipstick, add oil to bring
the oil level to the Full mark. Do not overfill the engine
with oil. If the oil level is between the Full and Add marks,
no additional oil is required.
1. Position the machine on a level surface.
2. Remove the dipstick and wipe it with a clean rag
(Figure 15).
1. Dipstick
2. Oil-fill cap
3. Insert the dipstick into the tube and make sure that it
is seated fully (Figure
4. Remove dipstick and check the level of the oil
15).
5. If the oil level is low, remove the oil-fill cap
and add enough oil to raise the level to the Full mark
on the dipstick.
6. Install the dipstick firmly in place
19
Figure 15
15).
(Figure
(Figure 15).
(Figure
15),