Maintenance Service
Interval
Every 800 hours
Every 1,000 hours
Note: Determine the left and right sides of the machine from the normal operating position.
DANGER
Only qualified and authorized personnel shall be permitted to maintain, repair, adjust, or inspect the
machine.
Avoid fire hazards and have fire protection equipment present in the work area. Do not use an open flame
to check level or leakage of fuel, battery electrolyte, or coolant. Do not use open pans of fuel or flammable
cleaning fluids for cleaning parts.
CAUTION
If you leave the key in the starter switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the starter switch before you do any maintenance.
Operating in Adverse Conditions
Important: If the machine is subjected to any of the conditions listed below, maintenance should be performed
twice as frequently:
•
Desert operation
•
Cold climate operation below 0° C (32° F)
•
Trailer towing
•
Frequent operation on dusty roads
•
Construction work
•
After extended operation in mud, sand, water, or similar dirty conditions, have your brakes inspected and cleaned as soon as
possible. This will prevent any abrasive material from causing excessive wear.
Maintenance Procedure
• Change the front-differential oil.
• Change the hydraulic fluid and clean the strainer.
• Replace the hydraulic filter.
• Change the high-flow hydraulic fluid and filter (TC models only).
• Change the brake fluid.
• Drain/flush the fuel tank.
• Flush or replace the coolant-system fluid.
33