Lubrication; Greasing The Bearings And Bushings - Toro 07385H Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 100 hours (lubricate more frequently
in heavy duty applications).
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium-Base Grease.
The grease fitting locations and quantities are as follows:
•
Ball joints (4), tie rods (2), pivot mounts (2) and steering
cylinder (2) (Figure 38)
•
Spring tower (2) (Figure
•
Clutch (1), accelerator (1), brake (qty.1)
•
U-joint (18) and 4 wheel drive shaft (3)
Important: When greasing the drive shaft universal
shaft bearing crosses, pump grease until it comes out
of all 4 cups at each cross.
1. Wipe each grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into each bearing or bushing.
3. Wipe off excess grease.
Figure 38
39)
(Figure 40)
(Figure 41)
38
Figure 39
Figure 40