2
Installing the Rollover
Protection System (ROPS)
Parts needed for this procedure:
1
ROPS frame
6
Bolt (1/2 inch)
Procedure
1. Align each side of the ROPS with the mounting holes
in the frame at each side of the vehicle as shown in
Figure
4.
1. ROPS-mounting bracket
2. Secure each side of the ROPS to frame with 3 flanged
bolts (1/2 x 1-1/4 inch), and tighten the bolts to 115
N-m (85 ft-lb).
Figure 4
2. Flanged bolts (1/2 x 1-1/4
inch)
3
Checking the Fluid Levels
No Parts Required
Procedure
1. Check the engine-oil level before and after the engine
is first started; refer to
(page
19).
2. Check the transaxle/hydraulic-fluid level before
the engine is first started; refer to
Transaxle/Hydraulic-fluid Level (page
3. Check the brake-fluid level before the engine is first
started; refer to
23).
13
Checking the Engine-oil Level
Checking the
21).
Checking the Brake-fluid Level (page