Specifications; Attachments/Accessories; Operation; Checking The Engine Oil Level - Toro Workman HD 07369 Operator's Manual

1. Seat adjusting lever

Specifications

Note: Specifications and design are subject to change
without notice.
Dimensions
Overall Width 63 inches (160 cm)
w/o bed: 128.25 inches (326 cm)
w/full bed: 130.38 inches (331 cm)
Overall Length
w/2/3 bed in rear mounting location:
136.38 inches (346 cm)
Base Weight (Dry) 1848 lb (838 kg)
Rated Capacity 3002 lb (1361.6 kg) (includes 200
lb (91 kg) operator, 200 lb (91 kg)
passenger, and loaded attachment).
Maximum. Gross 4,850 lb (2200 kg)
Vehicle Weight
Tow Capacity Tongue weight 600 lb (272 kg)
Maximum trailer weight 3,500 lb (1587
kg)
Ground Clearance 7 inches (18 cm) w/ no load
Wheel Base 70 inches (118 cm)
Wheel Tread (center Front: 46 inches (117 cm)
line to center line) Rear: 47.7 inches (121 cm)
Height 75 inches (190.5 cm) to top of ROPS

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
Figure 8

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.
Before servicing or making adjustments to
the machine, stop the engine, set the parking
brake, and remove the key from the switch.
Remove any load material from the bed or
other attachment before working under a
raised bed. Never work under a raised bed
without positioning the safety support on a fully
extended cylinder rod.

Checking the Engine Oil Level

Service Interval: Before each use or daily
The engine is shipped with approximately 2 quarts
(1.9 l) (w/ filter) of oil in the crankcase; however, you
should check the oil level before and after the engine
is first started.
Note: The best time to check the engine oil is when
the engine is cool before it has been started for the
day. If it has already been run, allow the oil to drain
back down to the sump for at least 10 minutes before
checking. If the oil level is at or below the Add mark
on the dipstick, add oil to bring the oil level to the Full
mark. Do not overfill. If the oil level is between the
Full and Add marks, no additional oil is required.
The engine uses any high-quality detergent oil having
the American Petroleum Institute (API) service
classification SH, SJ, or higher. Oil viscosity (weight) is
selected according to anticipated ambient temperature.
Temperature/ viscosity recommendations are as
follows:
• Above 0 degrees F (–20 degrees C)—Use 10W-30.
• Below 32 degrees F (0 degrees C)—Use SAE
5W-30.
Note: SAE 10W-40 and straight weight oils (SAE
30, etc.) are not recommended in Kohler engines due
to problems with pump-up of hydraulic lifters with
those oils. Either synthetic or mineral based oils may
be used, but oil drain intervals should be the same (per
recommendations).
1. Position the machine on a level surface.
2. Remove the dipstick (Figure 9) and wipe it with
a clean rag.
17