Specifications; Attachments/Accessories; Operation; Checking The Engine Oil Level - Toro 07383 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Dimensions
Overall Width 160 cm (63 inches)
w/o bed: 326 cm (128.25 inches)
w/full bed: 331 cm (130.38 inches)
Overall Length
w/2/3 bed in rear mounting location:
346 cm (136.38 inches)
Model 07383—736 kg (1623 lb)
Model 07384—885 kg (1951 lb)
Base Weight (Dry) Model 07384TC—921.6 kg (2032 lb)
Model 07386—912 kg (2010 lb) Model
07386TC—948 kg (2091 lb)
Rated Capacity Model 07383—1623 kg (3577 lb)
(includes 91 kg (200 lb) Model 07384—1474 kg (3249 lb)
operator, 91 kg (200 lb) Model 07384TC—1437 kg (3168 lb)
passenger and loaded Model 07386—1447 kg (3190 lb)
attachment) Model 07386TC—1410 kg (3109 lb)
Maximum. Gross 2359 kg (5200 lb)
Vehicle Weight
Tow Capacity Tongue weight: 272 kg (600 lb)
Maximum trailer weight: 1587 kg
(3,500 lb)
Ground Clearance 18 cm (7 inches) w/ no load
Wheel Base
118 cm (70 inches)
Wheel Tread (center Front: 117 cm (46 inches) Rear: 121
line to center line) cm (47.7 inches)
Height 190.5 cm (75 inches) to top of ROPS

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
CAUTION
Before servicing or making adjustments to the
machine, stop the engine, set the parking brake,
and remove the key from the switch. Remove any
load material from the bed or other attachment
before working under a raised bed. Never work
under a raised bed without positioning the safety
support on a fully extended cylinder rod.

Checking the Engine Oil Level

Service Interval: Before each use or daily
The engine is shipped with approximately 3.2 l (3.4 quarts)
(w/ filter) of oil in the crankcase; however, you should check
the oil level before and after the engine is first started.
Note: The best time to check the engine oil is when the
engine is cool before it has been started for the day. If it has
already been run, allow the oil to drain back down to the
sump for at least 10 minutes before checking. If the oil level is
at or below the Add mark on the dipstick, add oil to bring the
oil level to the Full mark. Do not overfill. If the oil level is
between the Full and Add marks, no additional oil is required.
The engine uses any high-quality 10W-30 detergent oil having
the American Petroleum Institute (API) service classification
SJ, SK, SL, SM, or higher. Choose a viscosity according to
the table in Figure 12.
1. Position the machine on a level surface.
2. Remove the dipstick (Figure 13)and wipe it with a clean
rag. Insert the dipstick into the tube and make sure
it is seated fully. Remove dipstick and check the level
of the oil.
17
G016095
Figure 12