Parking Brake - Toro 07385H Operator's Manual

1. Gear shift lever

2. Parking brake

3. Hydraulic bed lift
Parking Brake
Whenever the engine is shut off, set the parking brake
7) in order to prevent the machine from accidentally moving.
•
To set the parking brake, pull back on the lever.
•
To release, push the lever forward.
Note: Release the parking brake before moving the
machine.
If you park the machine on a steep grade, set the parking
brake, shift the transmission into first gear on a uphill grade
or reverse gear on a down hill grade, and place chocks at the
down hill side of the wheels.
Hydraulic Lift
The hydraulic lift raises and lowers the bed. Move it rearward
to raise the bed, and forward to lower it
Important: When lowering the bed, hold the lever in
the forward position for 1 or 2 seconds after the bed
contacts the frame to secure it in the lowered position.
Do not hold the hydraulic lift in either the raise or lower
position, for more than 5 seconds, once the cylinders
have reached the end of their travel.
Hydraulic-lift Lock
The hydraulic-lift lock locks the lift lever, so the hydraulic
cylinders do not operate when the machine is not equipped
with a bed (Figure 7). It also locks the lift lever in the On
position when using the hydraulics for attachments.
High–Low Range Shifter
The high–low range shifter adds 3 additional speeds for
precise speed control (Figure
•
The machine must be completely stopped before shifting
between the High and Low range.
•
Shift only on level ground.
Figure 7
4. Hydraulic lift lock
5. Differential lock
6. High–low range shifter
(Figure 7).
7):
•
Press the clutch pedal fully.
•
Move the lever fully forward for High and fully rearward
for Low.
High is for higher speed driving on level, dry surfaces with
light loads.
Low is for low-speed driving. Use this range when greater
than normal power or control is required. For example,
steep grades, difficult terrain, heavy loads, slow speed but
high-engine speed (spraying).
Important: There is a location between High and Low
in which the transaxle is in neither range. Do not use
this position as a neutral position because the vehicle
could move unexpectedly if the High–Low shifter is
bumped and the gear-shift lever is in gear.
Starter Switch
The starter switch is located to the right of the steering
column and below the indicator lights for the battery, engine
(Figure oil pressure, engine coolant temperature, glow plugs
8). Use the starter switch to start and stop the engine. The
switch has 3 positions: Off, On, and Start. Rotate the key
clockwise to the On position to activate the glow plugs.
When the glow plug indicator light turns off, rotate the key
counterclockwise to the Start position to start the engine.
To shut off the engine, rotate the key counterclockwise to
the Off position.
1. Light switch
2. High-flow-hydraulics
switch
(TC models only)
3. Horn
(TC models only)
4. Tachometer
5. Hour meter
6. Speedometer
7. Coolant-temperature
gauge and light
Note: Remove the key from the starter when leaving the
machine.
15
Figure 8
8. Fuel gauge
9. Ignition switch
10. Power point
11. 3rd high lockout switch
12. Oil pressure warning light
13. Glow-plug indicator
14. Charge indicator
(Figure