Adjusting The Parking Brake - Toro 07384 Operator's Manual

Figure 58
1. Brake-fluid reservoir
6. If the fluid level is low, clean the area around
the cap, remove the reservoir cap, and fill the
reservoir to the proper level with the specified
brake fluid (Figure
Note:
Do not overfill the reservoir with brake
fluid.
Adjusting the Parking
Brake
Service Interval: After the first 10 hours
Every 200 hours
1. Remove the rubber grip from the parking-brake
lever (Figure 59).
Figure 59
1. Grip
2. Loosen the set screw securing the knob to the
parking-brake lever
58).
2. Parking-brake lever
(Figure 60).
1. Knob
2. Set screw
g002379
3. Rotate the knob
to 22 kg (45 to 50 lb) is required to actuate the
lever.
4. Tighten the set screw when finished
Note:
If you can no longer make a parking-brake
adjustment by adjusting the parking-brake
lever, loosen the handle to the middle of the
adjustment and adjust the cable at the rear, then
repeat step 3.
5. Install the rubber grip onto the parking-brake
lever (Figure
g033487
52
Figure 60
3. Parking-brake lever
(Figure 60) until a force of 20
59).
g033488
(Figure 60).