Power Supply Cage Assembly - HP ProLiant DL380 G7 Maintenance And Service Manual

Close and lock the heatsink retaining latches.
4.
Install the air baffle
5.
If the PCI riser cage was removed, install the PCI riser cage.
6.
Install the access panel
7.
Install the server into the rack.
8.
Power up the server.
9.

Power supply cage assembly

To remove the component:
Power down the server (on page 26).
1.
Access the product rear panel (on page 28).
2.
Remove all power supplies
3.
Remove the server from the rack (on page 28).
4.
Remove the access panel
5.
Remove the PCI riser cage
6.
Remove the air baffle
7.
Remove the power supply backplane
8.
Loosen the system board thumbscrews, and then slide the system board assembly forward.
9.
("Air baffle" on page 32).
("Access panel" on page 31).
("Hot-plug power
("Access panel" on page 31).
("PCI riser cage" on page 33).
("Air baffle" on page 32).
("Power supply
supply" on page 36).
backplane" on page 39).
Removal and replacement procedures 61