Dimms - HP ProLiant DL380 G7 Maintenance And Service Manual

Close and lock the heatsink retaining latches.
8.
Install the air baffle
9.
If the PCI riser cage was removed, install the PCI riser cage.
10.
Install the access panel
11.
Install the server into the rack.
12.
Power up the server.
13.

DIMMs

IMPORTANT:
these two types causes the server to halt during BIOS initialization.
To identify the DIMMs installed in the server, see "DIMM identification (on page 97)."
To remove the component:
Power down the server (on page 26).
1.
Extend or remove the server from the rack
2.
server from the
Remove the access panel
3.
Remove the air baffle
4.
("Air baffle" on page 32).
("Access panel" on page 31).
This server does not support mixing RDIMMs and UDIMMs. Attempting to mix
rack" on page 27).
("Access panel" on page 31).
("Air baffle" on page 32).
("Remove the server from the
Removal and replacement procedures 70
rack" on page 28, "Extend the