Optical Drive - HP ProLiant DL380 G7 Maintenance And Service Manual

NOTE:
the redundant power supply can be removed without disconnecting the power cord from the
primary power supply.
Close the cable management arm.
5.
Connect the power cord to the power source.
6.
Be sure that the power supply LED is green
7.
Be sure that the power supply LED on the SID is green
8.

Optical drive

To remove the component:
CAUTION:
all bays are populated with either a component or a blank.
Power down the server (on page 26).
1.
Extend or remove the server from the rack
2.
server from the
Remove the access panel
3.
Disconnect the cable from the optical drive.
4.
If using the power cord anchor, be sure to leave enough slack in the power cord so that
To prevent improper cooling and thermal damage, do not operate the server unless
rack" on page 27).
("Access panel" on page 31).
("Rear panel LEDs and
("Systems Insight Display
("Remove the server from the
Removal and replacement procedures 37
buttons" on page 92).
LEDs" on page 89).
rack" on page 28, "Extend the