Processor - HP ProLiant DL380 G7 Maintenance And Service Manual

Remove the power supply cage assembly.
10.
To replace the component, reverse the removal procedure.

Processor

CAUTION:
should attempt to replace or install the processor in this server.
CAUTION:
configurations must contain processors with the same part number.
IMPORTANT:
server does not power up.
To remove a processor:
Power down the server (on page 26).
1.
Extend the server from the rack (on page 27).
2.
Remove the access panel
3.
If full-length expansion boards are installed, remove the PCI riser cage.
4.
Remove the air baffle
5.
To avoid damage to the processor and system board, only authorized personnel
To prevent possible server malfunction and damage to the equipment, multiprocessor
Processor socket 1 must always be populated. If processor socket 1 is empty, the
("Access panel" on page 31).
("Air baffle" on page 32).
Removal and replacement procedures 62