Hot-Plug Power Supply - HP ProLiant DL380 G7 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Hot-plug power supply

WARNING:
power supply blank to cool before touching it.
CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Determine how many hot-plug power supplies are installed:
1.
If only one hot-plug power supply is installed, power down the server.
o
If more than one hot-plug power supply is installed, continue with the next step.
o
Disconnect the power cord from the source.
2.
Access the product rear panel (on page 28).
3.
Remove the power cord from the server.
4.
Remove the hot-plug power supply.
5.
WARNING:
power cord to the power supply until the power supply is installed.
To replace the component:
Slide the hot-plug power supply into the power supply bay.
1.
Connect the power cord to the power supply.
2.
Install the cable management arm, if removed
3.
Route the power cord through the cable management arm or power cord anchor.
4.
To reduce the risk of personal injury from hot surfaces, allow the power supply or
To prevent improper cooling and thermal damage, do not operate the server unless
To reduce the risk of electric shock or damage to the equipment, do not connect the
("Access the product rear
Removal and replacement procedures 36
panel" on page 28).