Lubrication; Greasing Bearings And Bushings - Toro 07362 Operator's Manual

Lubrication

Greasing Bearings and
Bushings
Service Interval: Every 100 hours
The vehicle has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. If machine is operated under normal conditions,
lubricate all bearings and bushings after every 100 hours
of operation. More frequent lubrication is required if
used for heavy duty vehicle operations.
The grease fitting locations and quantities are: Steering
pitman arm (1) and Steering ball joint ends (2)
(Figure 41), Tie rod ends (4) (Figure 42), Front ball
joints (4) (Figure 42), Rear drive shafts (18) (Figure 43),
Pedal pivots (3) (Figure 446); Front pivot bushings (2)
(Figure 45) and Accelerator arm (1) (Figure 46).
Important: When greasing drive shaft universal
shaft bearing crosses, pump grease until it comes
out of all 4 cups at each cross.
1. Wipe grease fitting clean so foreign matter cannot be
forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
Figure 41
40
Figure 42
Figure 43
Figure 44