Setup; Install The Rear Fenders - Toro 07362 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Parts Manual
Note: Determine the left and right side of the machine
from the normal operating position.
Description
Rear fender
Bolts, 3/8 x 1–1/4 in
Locknut, 3/8
Support plate
Wheel nut
Front wheel
Wheel nut
Rear wheel
Steering wheel
Cap
Washer
Foam seal
Front fender
Socket hex head bolt, #10 x 3/4" in.
Washer, .210 I.D.
Locknut, #10
ROPS frame
bolt 1/2 x 3" in.
Locknuts 1/2
Qty.
2
10
2
2
10
2
10
2
1
1
1
1
2
10
20
10
1
4
4
Qty.
1
Read before operating the vehicle
1 Use to reference part numbers
1

Install the Rear Fenders

Parts needed for this procedure:
2 Rear fender
10 Bolts, 3/8 x 1–1/4 in
2 Locknut, 3/8
2 Support plate
Procedure
1. Loosen the locknuts and bolts securing tail light
brackets to right and left frame brackets (Figure 3).
2. Pivot tail light brackets rearward and tighten bolts
and locknuts.
13
Use
Mount the rear fenders.
Mount the wheels.
Install the steering wheel.
Install the front fenders.
Mount the ROPS (Rollover Protection
System)
Use