Adjusting High-Low Cable; Inspect Tires; Front Wheel Toe - Toro 07362 Operator's Manual

Liquid cooled diesel utility vehicle
Hide thumbs Also See for 07362:
Table of Contents

Advertisement

1. Shift arm (1st – Rev.)
2. Shift arm (2nd – 3rd)
3. Loosen clevis jam nuts and adjust each clevis so
cable free play is equal forward and backward relative
to hole in transaxle shift arm (With transaxle lever
free play taken up in same direction).
4. Reinstall clevis pins and tighten jam nuts after
adjustments have been attained.
Adjusting High–low Cable
Service Interval: After the first 10 hours
Every 200 hours
1. Move differential lock lever to Off position.
2. Loosen jam nuts securing differential lock cable to
bracket on transaxle.
3. Adjust jam nuts to obtain .035" ± .025" gap between
spring hook and O.D. of hole in transaxle lever.
4. Tighten jam nuts after adjustment has been attained.

Inspect Tires

Service Interval: Every 100 hours
Operating accidents, such as hitting curbs, can damage a
tire or rim and also disrupt wheel alignment, so inspect
tire condition after an accident.

Front Wheel Toe

Service Interval: Every 400 hours/Yearly (whichever
comes first)
1. Measure center–to–center distance (at axle height) at
front and rear of steering tires. The measurement
Figure 55
3. Shift arm (High–low)
must be .12 .12" greater at the front of the tire than
at the rear.
1. Front of vehicle
2. .12 ± .12 inch greater than
rear of tire
2. Adjust the center–to–center distance as follows:
• On the right front wheel, loosen the jam nuts at
both ends of the tie rod (Figure 57).
1. Tie rod
• On the left front wheel, loosen the jam nuts at
both ends of the turn buckle (Figure 58).
• Rotate the tie rod and turnbuckle evenly to move
the front of the tire inward or outward to achieve
the center to center distances from front to back.
• Tighten tie rod and turnbuckle jam nuts when
the adjustment is correct.
• Check to make sure the tires turn an equal
amount to the right and to the left. If the tires do
not turn equally, refer to the Workman Service
Manual for the adjustment procedure
46
Figure 56
3. Center to center distance
Figure 57

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

07362tc0736407364tcWorkman 3300-dWorkman 4300-d

Table of Contents