Jacking Vehicle - Toro 07362 Operator's Manual

4. To store bed support, remove bed support from
cylinder and insert into brackets on back of ROPS
panel.
5. Always install or remove bed support from outside
of bed.
Do not try to lower bed with bed safety support
on cylinder.

Jacking Vehicle

A vehicle on a jack may be unstable and slip off
of the jack, injuring anyone beneath it.
• Do not start the vehicle while the vehicle is
on a jack.
• Always remove the key from the switch
before getting off of the vehicle.
• Block the tires when the vehicle is on a jack.
1. Do not start engine while vehicle is on jack, because
engine vibration or wheel movement could cause
vehicle to slip off jack.
2. Do not work under vehicle without jack stands
supporting it. The vehicle could slip off jack, injuring
any one beneath it.
3. The jacking point at the front of the vehicle is under
the front center frame support and at the rear it is
under the axle tube.
4. When jacking up front of vehicle, always place a 2x4
block (or similar material) between jack and vehicle
frame.
Figure 39
1. Front jacking point
39
Figure 40