Toro 07362 Operator's Manual page 55

Jumping Hydraulic System
Before servicing or making adjustments to the
machine, stop engine, set parking brake and
remove key from the switch. Any load material
must be removed from bed or other attachment
before working under raised bed. Never work
under a raised bed without positioning safety
support on a fully installed cylinder rod.
Note: Two hydraulic hoses, each with a male and
female quick coupler, that fit the vehicle couplers are
required to perform this operation.
• Back another vehicle up to the rear of the disabled
vehicle.
Important: The vehicles hydraulic system uses
Dexron IIl ATF. To avoid system contamination,
make sure vehicle used to jump hydraulic system
uses an equivalent fluid.
• On both vehicles, disconnect the two quick coupler
hoses from the hoses secured to the coupler bracket
(Figure 78).
1. Quick coupler hoses
• On the disabled vehicle, connect the two jumper
hoses to the hoses that were disconnected
(Figure 79). Cap unused fittings.
Figure 78
1. Disconnected hoses
• On the other vehicle, connect the two hoses to the
coupler still in the coupler bracket (Connect the top
hose to the top coupler and the bottom hose to the
bottom coupler (Figure 80). Cap unused fittings.
1. Jumper hoses
• Keep all bystanders away from the vehicles.
• Start second vehicle and move lift lever to the raise
position which will raise the disabled box.
• Move the hydraulic lift lever to the neutral position
and engage the lift lever lock.
• Install the bed safety support onto the extended lift
cylinder. Refer to Using the Bed Safety Support.
Note: With both the vehicles turned off, move
the lift lever back and forth to remove the system
55
Figure 79
2. Jumper hoses
Figure 80