Electrical System Maintenance; Fuses; Jump Starting Vehicle; Battery Care - Toro 07362 Operator's Manual

Electrical System
Maintenance

Fuses

The fuses for the machine's electrical system are located
under the center of the dash panel.
Figure 52
1. Fuses
Figure 53

Jump Starting Vehicle

Jump starting can be dangerous. To avoid
personal injury or damage to electrical
components in vehicle, observe the following
warnings:
• Never jump start with a voltage sources
greater than 15 volts D.C. This will damage
the electrical system.
• Never attempt to jump start a discharged
battery that is frozen. It could rupture or
explode during jump starting.
• Observe all battery warnings while jump
starting your vehicle.
• Be sure your vehicle is not touching the
jump start vehicle.
• Connecting cables to the wrong post could
result in personal injury and/or damage to
the electrical system.
1. Loosen knobs securing battery cover to battery base
and slide cover off.
2. Connect a jumper cable between the positive posts
of the two batteries. The positive post may be
identified by a "+" sign on top of battery cover.
3. Connect one end of the other jumper cable to the
negative terminal of the battery in the other vehicle.
The negative terminal has "NEG" on the battery
cover. Do not connect the other end of the jumper
cable to the negative post of the discharged battery.
Connect it to the engine. Do not connect the jumper
cable to the fuel system.
4. Start the engine in the vehicle providing the jump
start. Let it run a few minutes, then start your engine.
5. Remove the negative jumper cable first from your
engine, then the battery in the other vehicle.
6. Reinstall battery cover to battery base and tighten
knobs.

Battery Care

Service Interval: Every 50 hours (Every 30 days if in
storage)
Every 50 hours
1. Battery electrolyte level must be properly maintained
and the top of the battery kept clean. lf the machine
is stored in a location where temperatures are
extremely high, the battery will run down more
44