Adjusting Brake Pedal; Adjusting Clutch Pedal - Toro 07362 Operator's Manual

1. .200 — .350 inch Clearance
3. Maximum high idle speed 3650 rpm. High idle stop
should not be adjusted.

Adjusting Brake Pedal

Service Interval: Every 200 hours (Front hood can be
removed to ease adjustment.)
1. Remove cotter pin and clevis pin securing master
cylinder yoke to brake pedal pivot (Figure 67).
1. Master cylinder yoke
2. Lift up on brake pedal (Figure 68) until it contacts
frame.
3. Loosen jam nuts securing yoke to master cylinder
shaft (Figure 67).
Figure 66
Figure 67
2. Brake pedal pivot
4. Adjust yoke until its holes align with hole in brake
pedal pivot. Secure yoke to pedal pivot with clevis
pin and cotter pin.
5. Tighten jam nuts securing yoke to master cylinder
shaft.
Note: The brake master cylinder must relieve
pressure when properly adjusted.
1. Brake pedal

Adjusting Clutch Pedal

Service Interval: Every 200 hours
Note: The clutch pedal cable can be adjusted at the bell
housing or at the clutch pedal pivot. The front hood can
be removed to ease the access to pedal pivot.
1. Loosen the jam nuts securing the clutch cable to the
bracket on the bell housing (Figure 691).
1. Clutch cable
2. Jam nuts
Note: The ball joint may be removed and rotated, if
additional adjustment is required.
2. Disconnect the return spring from the clutch lever.
3. Adjust the jam nuts/or ball joint until the back rear
edge of the clutch pedal is 3.75" + .12" from the top
51
Figure 68
2. Clutch pedal
Figure 69
3. Return spring
4. Ball joint