Drive System Maintenance; Changing The Front Differential Oil (Four-Wheel Drive Models Only); Inspecting The Constant Velocity Boot (Four-Wheel Drive Models Only) - Toro 07385 Operator's Manual

Utility vehicle with bed
Hide thumbs Also See for 07385:
Table of Contents

Advertisement

Keep battery electrolyte level properly maintained.
Keep the top of the battery clean by washing it periodically
with a brush dipped in ammonia or bicarbonate of soda
solution. Flush the top surface with water after cleaning.
Do not remove the fill cap while cleaning.
Ensure that the battery cables are kept tight on the
terminals to provide good electrical contact.
If corrosion occurs at terminals, remove the battery
cover, disconnect the cables (negative (–) cable first), and
scrape the clamps and terminals separately. Reconnect
the cables (positive (+) cable first) and coat the terminals
with petroleum jelly.
Maintain cell electrolyte level with distilled or
demineralized water. Do not fill the cells above the
bottom of the fill ring inside each cell.
If you store the machine in a location where temperatures
are extremely high, the battery will run down more
rapidly than if the machine is stored in a location where
temperatures are cool.
Drive System
Maintenance
Changing the Front Differential
Oil (Four-wheel drive models
only)
Service Interval: Every 800 hours
1. Position the vehicle on a level surface, stop the engine,
engage the parking brake and remove the key from the
ignition switch.
2. Clean the area around the drain plug on the side of
the differential (Figure 50). Place a drain pan under
the drain plug.
1. Fill/check plug
3. Remove the drain plug and let the oil flow into the
drain pan. Install and tighten the plug when the oil
stops draining.
4. Clean the area around the fill/check plug on the
bottom of the differential.
5. Remove the fill/check plug and add Mobil 424
hydraulic oil until the oil is up to the hole.
6. Install the fill/check plug.
Inspecting the Constant
Velocity Boot (Four-wheel
drive models only)
Service Interval: Every 200 hours
Inspect the constant velocity boot for cracks, holes, or a loose
clamp. Contact your Authorized Toro Distributor for repair
if you find any damage.
43
Figure 50
2. Drain plug

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

07385tc07387tcWorkman hdx-d07387

Table of Contents