Fuel Gauge; Light Switch; Oil Pressure Warning Light - Toro 07385 Operator's Manual

3rd High Lockout Switch
Move the 3rd high lockout switch (Figure 10) to the slow
position and remove the key to prevent the use of third gear
when in the High range. The engine will shut off if the shift
lever is moved to third gear when in High range. The key is
removable in either position.

Light Switch

Push the light switch (Figure 10) to toggle the headlights on
or off.

Oil Pressure Warning Light

The oil pressure warning light glows (Figure 10) if the engine
oil pressure drops below a safe level while the engine is
running. If the light flickers or remains on, stop the vehicle,
turn off the engine, and check the oil level. If the oil level was
low, but adding oil does not cause the light to go out when
the engine is restarted, turn the engine off immediately and
contact your local Toro distributor for assistance.
Check the operation of warning lights as follows:
1. Apply the parking brake.
2. Turn the ignition key to the On/Preheat position, but
do not start the engine. The oil pressure light should
glow red. If the light does not function, either a bulb
is burned out or there is a malfunction in the system
which must be repaired.
Note: If engine was just turned off, it may take 1 to 2
minutes for the light to come on.
Glow Plug Indicator
Glow plug indicator (Figure 10) will glow red when the glow
plugs are activated.
Important: The glow plug indicator will turn on, for an
additional 15 seconds, when the switch returns to the
Start position.
Coolant Temperature Gauge and Light
Registers the coolant temperature in the engine. Operates
only when the ignition switch is in On position (Figure 10).
The indicator light will illuminate blinking red if the engine
overheats.
Charge Indicator
Illuminates when battery is being discharged. If light
illuminates during operation, stop vehicle, turn off engine and
check for possible causes, such as alternator belt (Figure 10).
Important: If alternator belt is loose or broken, do
not operate the vehicle until adjustment or repair is
complete. Failure to observe this precaution may result
in damage to the engine.
Check the operation of warning lights as follows:
•
Apply parking brake.
•
Turn the ignition key to the On/Preheat position, but do
not start the engine. The coolant temperature, charge
indicator, and oil pressure lights should glow. If any light
does not function, either a bulb is burned out or there is a
malfunction in the system which must be repaired.

Fuel Gauge

The fuel gauge shows the amount of fuel in the tank. It
operates only when ignition switch is in the On/Preheat
position (Figure 10). Red indicates low fuel level and blinking
red indicates near empty.
High Flow Hydraulics Switch (TC
models only)
Turn on the switch to activate the high flow hydraulics
(Figure 10).
Horn Button (TC models only)
Pressing the horn button activates the horn (Figure 10).
Tachometer
Registers the speed of the engine (Figure 10 & Figure 11).
White triangle indicates desired rpm for PTO operation
(Figure 11).
1. Speed of the engine
Speedometer
Registers the ground speed of the vehicle (Figure 10). The
speedometer is in mph but can easily converted to km/h.
Refer to Converting the Speedometer (page 50).
Power Point
Use the power point (Figure 10) to power optional 12 volt
electrical accessories.
17
Figure 11
2. 3,300 rpm for 540 rpm
PTO operation