Audio Tones - Xerox WorkCentre 7132 User Manual

Audio Tones

Control Panel Select Tone
Control Panel Alert Tone
Machine Ready Tone
Copy Job Complete Tone
Non-Copy Job Complete Tone
Fault Tone
Alert Tone
Out of Paper Warning Tone
Low Toner Alert Tone
Xerox WorkCentre 7132 User Guide
Downloaded From ManualsPrinter.com Manuals
This feature allows you to select the volume level of tones to be generated at various
occasions. You can choose different volume levels for each item shown on the screen.
1.
Select [Audio Tones] on the
[Common Settings] screen.
2.
Change the required settings.
Use the side tabs to switch
between screens.
3.
Select [Close].
Specifies the volume level of the tone generated when an appropriate button on the
control panel is pressed and its action is accepted.
Specifies the volume level of the tone generated when an inappropriate button on the
control panel is pressed.
Specifies the volume level of the tone generated when the machine becomes ready to
copy or print, for example, after the power is switched on.
Specifies the volume level of the tone generated when copying finishes successfully.
Specifies the volume level of the tone generated when a job other than copying finishes
successfully.
Specifies the volume level of the tone generated when a job did not finish properly.
Specifies the volume level of the tone generated when a job is suspended due to an
error.
Specifies the volume level of the tone generated when the machine runs out of paper.
Specifies the volume level of the tone generated when it is time to replace the toner
cartridge.
Common Settings
223